How to Fix No Display / Computers Motherboard Problem?

Solution 1 – Monitor Checkup.

The first thing you have to make your monitor is “Power on” and then check the video cable is connected properly or not. You can check for loose connection by unplugging and plug it back again.

Solution 2 – Graphic Hardware Checkup

If you have a graphic card installed in your motherboard, then you should remove it and plug your monitors video cable directly to the motherboard and try to start your computer again. If your computer starts normally that means you have a faulty graphic

Solution 3 – CMOS Battery Checkup

Sometimes motherboards cmos battery got drained and starts creating problems and maybe prevent your computer to starts up. In that case you can remove your cmos battery and try to start your computer again. If your computer starts, then change motherboards cmos battery and try to start your computer again.

Solution 4 – Ram Checkup

(A) Commonly Ram must be the 90% of reason for “no display” problem, If you have two ram installed in your computer, then remove one of them and try to turn on your computer. If your computer still wont turn on then remove that ram from that slot and install it into another slot. If your computer still wont able to Turn ON, then do those previous steps with your other ram, If you still facing that problem that means there is chance your ram got dead, in that case borrow a compatible “Ram” and checks it again If you find your Ram dead, then its Ram problem. you can try to clean it And then check that ram does it works after cleaning. If the cleaning doesnt work but replaced new ram works thats sure your ram has problem and need to replace.

(B) Cleaning Ram Contacts - cleaning that part soldier joines

Solution 5 – Processor Checkup

You can try to check your motherboard by installing other process into it to know, does your processor creates problem or not. Otherwise you have motherboard problem. Turn your computer on and let it run for a while. Carefully touch the processor. If it is too hot to touch for more than a few seconds, your processor is overheating. Remove the heatsink from the top of the processor and reseat it. Unclip the processor from the motherboard. Check for any obvious damage such as burnt material, which would mean the processor has failed. Attach the processor and heatsink to the second test computer, which uses the same

type of processor. And test it.

Have many solution on Youtube, either you follow the steps above or you can see the steps shown on these video.

Source:https://www.deskdecode.com/how-to-fix-no-display-computers-motherboard-problem/